Installing modules in columns
It is possible to combine up to 4 modules in one column. Table 7 below shows
the compatibility of detector models in one column.
Table 7: Detector models compatibility
SB250-N SB450-N SB2100-N SB4100-N SB4200-N
SB250-N Yes Yes No No No
SB450-N Yes Yes No No No
SB2100-N No No Yes Yes No
SB4100-N No No Yes Yes No
SB4200-N No No No No Yes
We do not recommend mixing detectors of different generations (for example,
SB250 and SB250-N) or brands in a same column.
Connections
Mount the modules as described in “Installation” on page 4.
Connect the modules between themselves via the inter-module connections A
and B (connect the A’s to the A’s and the B’s to the B’s).
Recommendation: wire the alarm relays on the module 2 (the second module
from the bottom of the column) because this module is recommended to be
selected as “Master”.
SB Series AIR Beam Detectors In
stallation Manual 15
To Next Page
Loading...
Need help?
General
