Interlogix Simon XT Installation Manual

Simon XT Installation Manual 17
Installation
This section describes how to open the panel for mounting, mount the panel,
connect sirens, connect hardwired contacts, and connect the AC power
transformer.
UL listed installations
Some installations may require configurations dictated by city/state codes,
insurance, or Underwriter’s Laboratories (UL). This section describes the various
component and configuration listings.
Basic system:
• Control panel: backup battery 6 V 1.2 Ah (34-025) (Portalac model #
PE6V1.2)
• Standard class 2, 9 VAC, 3.34 A power transformer (UTC Fire & Security Part
22-153). Alternate transformer for US installations: MG Electronics Model
MGT925, 9 VAC, 25 VA, (UTC Fire & Security Part 22-155).
• Hardwired siren (13-374)
Household burglary alarm system unit (UL 1023), basic system plus the
following:
• Hardwired magnetic contact (13-068 or 13-071) or wireless learn mode
door/window sensor (60-670)
• Panel piezo beeps set to on
• Entry delay set to 45 seconds or less
• Exit delay set to 60 seconds or less
• RF time-out set to 24 hours
• Control panel alarms turned on
• Autoarm set to on
• Siren timeout set to five minutes or more
• Trouble beeps set to on
• RF jam detect set to on
• Hardwired siren supervision set to on
• Exit extension set to off
• Quick exit set to off
Household fire warning system (UL 985), basic system plus the following:
• Wireless smoke sensor 60-848-95 learned into sensor group 26
• Panel piezo beeps turned on
• Control panel alarms set to on
• Siren timeout set to four minutes or more
• Trouble beeps set to on
• RF jam detect set to on

Interlogix Simon XT Specifications

Power

power requirements	6V nominal
standby current	30mA (10mA in PowerSave Mode)
peak current	1.7 A

Operating Environment

operating temperature	32 to 120°F (0 to 49°C)
storage temperature	-30 to 140°F (-34 to 60°C)
max. relative humidity	90% non-condensing

Dimensions

height	4 1/16 in.
width	1 7/8 in.