Interlogix Simon XT Installation Manual

34 Simon XT Installation Manual
System Tests
Sensor Test
Communication Test
Initiate Download Call
Revision
Contrast
Set clock
If the panel loses both AC and battery power, then upon power restoral the
system time will reset to midnight and blink, indicating it has not been set
correctly. You can set the system time to display in either 12-hour or 24-hour
format.
Time of day format is HH:MMx, where:
HH = 01 to 12 (12-hour format) or 00 to 23 (24-hour format)
MM = 00 to 59
X = a or p (12-hour format) or none (24-hour format)
To reset the clock:
1. Scroll until the display shows Set Clock, and then press OK.
The display shows Enter Code.
2. Enter your code with the numeric keys, and then press OK.
The display flashes the hours.
3. Scroll to set the hours, and then press OK to accept the setting.
The display flashes the minutes.
4. Scroll to set the minutes, and then press OK to accept the setting.
The display flashes AM/PM.
5. Scroll to set the AM/PM, and then press OK to accept the setting.
The display shows the current time and stops flashing.
6. Press Status twice to exit.
Set date
If the panel loses both AC and battery power, then upon power restoral the
system date will reset.
Date format is YYYY-MM-DD, where:
YYYY = year

Interlogix Simon XT Specifications

Power

power requirements	6V nominal
standby current	30mA (10mA in PowerSave Mode)
peak current	1.7 A

Operating Environment

operating temperature	32 to 120°F (0 to 49°C)
storage temperature	-30 to 140°F (-34 to 60°C)
max. relative humidity	90% non-condensing

Dimensions

height	4 1/16 in.
width	1 7/8 in.