Interlogix Simon XT Installation Manual

Simon XT Installation Manual 35
MM = month
DD = day
To set the date:
1. Scroll until the display shows Set Date, and then press OK.
The display shows Enter Code.
2. Enter your code with the numeric keys, and then press OK.
The display shows the date.
3. Press OK.
The display flashes the year.
4. Scroll to set the year, and then press OK to accept the setting.
The display flashes the month.
5. Scroll to set the month, and then press OK to accept the setting.
The display flashes the day.
6. Scroll to set the day, and then press OK to accept the setting.
The display shows the programmed date.
7. Press Status twice to exit.
Revision
To display the firmware revision of the system, scroll until the display shows
Revision. This is a read-only menu. Press Status to exit.
Contrast
To adjust the contrast of the display:
1. Scroll until the display shows Contrast, and then press OK.
2. Scroll to increase or decrease the contrast setting,
3. Press Status to save the setting and exit.
Note: Changes in contrast are more noticeable when not looking at the display
straight on.

Interlogix Simon XT Specifications

Power

power requirements	6V nominal
standby current	30mA (10mA in PowerSave Mode)
peak current	1.7 A

Operating Environment

operating temperature	32 to 120°F (0 to 49°C)
storage temperature	-30 to 140°F (-34 to 60°C)
max. relative humidity	90% non-condensing

Dimensions

height	4 1/16 in.
width	1 7/8 in.