Interlogix TruVision 6 Series - Cable Requirements

24 Installation Guide
Caution: Risk of explosion if the battery is replaced by an
incorrect type. Dispose of used batteries according to the
instructions.
Cable requirements
For proper operation, adhere to the following cable and power
requirements for the cameras. Category 5 cabling or better is
recommended. All network cabling must be installed according
to applicable codes and regulations. Table 1 lists the
requirements for the cables that connect to the camera.
Table 1: Recommended power requirements
IP
fixed lens bullet camera: 12 VDC or PoE (802.3af)
IP
motorized lens bullet camera: 12 VDC or PoE+ (802.3at)
IP
fixed lens turret camera: 12 VDC or PoE (802.3af)
IP motorized lens turret camera:
12 VDC or PoE (802.3af)
IP fixed lens dome camera:
12 VDC or PoE (802.3af)
IP
motorized lens dome camera: 12 VDC or PoE (802.3af)
IP fixed lens wedge camera
: 12 VDC or PoE (802.3af)