the detection area position, re-click the icon and draw the area again.
Motion detection: This is used to detect motion in a selected area.
Click the icon and then drag the mouse to draw the motion detection area.
Note: It is not necessary to have motion detection enabled to use this feature.
Motion detection: This is used to detect motion over the whole image.
Click the icon. By default, the whole image is selected as the detection area.
Clear all areas selected.
Start and stop video clipping.
File management for video clips.
Stop playback.
Start or pause playback.
Smart settings.
Search matched video files.
5. Click Smart Settings to select the settings for the smart search:
Skip non-related video: Video that does not have selected events will not be
played.
Play non-related video: Set the speed to play the video with no selected events.
Play related video: Set the speed to play the video with selected events.
6. Click Search to search and play back video with the matched events, which are
shown in the Smart bar.
Split-screen playback
This feature lets you see simultaneously the 24-hour playback recording for a selected
camera split over several consecutive time periods.
You can display the recording between four and 16 split screens. The recording is split
into equals time periods depending on the number of split screens selected. See
Figure 16 below.
To Next Page
Loading...
