Interlogix TruVision DVR 15HD - PTZ Presets and Tours

Chapter 10: Camera setup
TruVision DVR 15HD User Manual 77
Note: If a camera does not work correctly after configuring the recorder, check the
parameters entered.
To configure PTZ dome camera settings:
1. Click the PTZ Control icon on the live view toolbar.
– Or –
From the menu toolbar, click Camera Setup > PTZ Setup.
2. Select the camera, baud rate, data bit, stop bit, parity, flow control, PTZ protocol and
address for the camera. See Appendix E “Default menu settings” on page 156 for
the default values.
Note: It is important to ensure that the settings correspond with those used in the
PTZ camera.
3. Click Copy to copy the settings to another camera, if required, and select the
cameras.
4. Click Apply to save the settings and then click Exit to return to live view.
PTZ presets and tours
Presets are previously defined locations of an analog PTZ dome camera. It allows you
to quickly move the PTZ dome camera to a desired position. They are configured and
modified from the Camera Setup > PTZ Presets/Tours window (see Figure 22 below).
Tours are series of presets. Shadow tours allow you to record the manual movement of
a PTZ and follow the same tour at a later date.
Note: The PTZ dome camera used must be able to support a preset command. See
Appendix D “Supported PTZ commands” on page 153 for the complete list of PTZ
commands available by camera protocol.