66
EN
Any use other than the intended use is considered incorrect use. The legal warranty is voided by any inter-
ference with, or modications to, the device.
Danger due to insufcient wire cross-section!
If wires with an insufciently large cross-section are used, short circuits or res may occur.
− Only use terminals with a cross-section between 1mm² and 2.5mm² for wires.
WARNING!
Damage to the DIN-rail timer due to incorrect installation location!
If installed in an unsuitable location, the DIN-rail timer may be damaged.
− Only use the DIN-rail timer in dry rooms and do not install close to devices with induc-
tive discharge (motors, transformers, etc.).
− Only install the DIN-rail timer on DIN rails.
NOTE!
Residual risks
The device is state-of-the art and designed in accordance with current safety requirements.
However, residual risks remain that require caution when using the device. The residual risks, and the
conduct and measures they require, are listed in the following.
FCC Certication
FCC ID: 2AHH/-DG
This device complies with Section 15 of the FCC Regulations. Operation is only permitted under the follow-
ing conditions: (1) This device must not cause any disruptive interferences and (2) the device must be able
to receive interferences, also such interferences which could result in undesired operations.
Electric current
Risk of fatal electric shock!
Improper assembly and installation of the device can lead to life-threatening electrical
voltages.
− Only allow a qualied electrician to install and connect the device.
WARNING!
To Next Page
Loading...
Need help?
General
