Chapter 4 — Configure the Computer
CV61 Vehicle Mount Computer (Windows 7) User Guide 57
5 For Security type, choose WPA-Personal or WPA2-Personal and
select TKIP or AES. The Encryption type automatically defaults to
AES.
6 For Network Security Key, enter the pre-shared key or the
passphrase.
The pre-shared key must be a value of 32 hex pairs preceded by 0x
for a total of 66 characters. The value must match the key value on
the authenticator. The passphrase must be from 8 to 63 characters.
After you enter a passphrase, the computer internally converts it to
a pre-shared key.
7 Tap OK to save the Microsoft Security settings.
Configure 802.1x Security with Microsoft
Use the following procedure to configure 802.1x security with
Microsoft security. Intermec recommends that you use WPA2-802.1x
instead of 802.1x-WEP if possible.
1 Make sure the communications and radio parameters on your
computer are configured.
2 Tap Start > Control Panel. The Control Panel appears.
3 In the View by: drop-down menu, select either Large or Small
icons.
4 Tap Network and Sharing Center > Manage Wireless Networks
and select the wireless network you want to configure.
5 For Security type, choose 802.1x.
6 In the Choose a network authentication method, choose either
LEAP, EAP-FAST, PEAP, or Smart Card or other certificate.
7 If you choose LEAP:
a Tap Settings. The Properties screen appears.
b Enter a User Name and a Password. When you are finished,
type in your password again in Confirm Password.
c Tap OK to exit the Properties screen.
d Tap OK again to save the Microsoft Security Settings.
To Next Page
Loading...
