HelvC
NugFont
Code39
Specifications
A-3
A
Printer Specifications
This section describes the specifications that are common to the 3400, 3440, and
3600 printers.
Electrical Requirements
Input Voltage 100, 120, or 240 VAC ± 10%
Frequency 47-63 Hz
Printing Method
The 3400, 3440, and 3600 printers are capable of direct thermal (DT) printing or
thermal transfer (TTR) printing using thermal transfer ribbon.
Environment
Operating 50°F to 104°F (10°C to 40°C)
Humidity 10% to 90% noncondensing
Self-Strip
The self-strip rewinder hub can take up the backing of an entire 6,000-inch roll
of media.
Peel Release 10-50 grams
Note: For the 3400C
rinter, sel
-stri
rintin
is an o
tion that
ou order with
our
printer. Self-strip printing is standard on the 3400B.
Communications
Asynchronous RS-232C, RS-422, RS-485 interfaces
Serial ASCII code
Hardware (Ready/Busy) Flow Control
XON/XOFF Protocol
Intermec Standard Block Protocol
Polling Mode D Protocol
Multi-Drop Protocol
Baud Rates: 1,200, 2,400, 4,800, 9,600, 19,200, 38,400
The following table provides the maximum baud rates for the printers.
Printer Maximum Baud Rate
3400B 19,200
3400C 38,400
3440 57,600
3600 19,200
To Next Page
Loading...
