3400, 3440, and 3600 Bar Code Label Printer User’s Manual
HelvC
NugFont
Code39
6-6
Performing Selective Transfer
If you want to copy select formats, pages, fonts, or graphics to another printer,
use the selective transfer command. Use this command to set up different
printers to print the same label formats.
Using the selective transfer command, you can transfer the following label
design attributes from one 3400, 3440, or 3600 printer to another:
•
Any specified page or all pages
•
Any specified format or all formats
•
Any specified font or all fonts
•
Any specified user-defined character (UDC) or all UDCs
When you set the printer DIP switches to the setting for selective transfer, the
printer serial port is set at 19,200 baud, even parity, 1 stop bit, and 8 data bits.
Set the receiving printer to these communication settings and power it up in
Print mode.
You may set the DIP switch communications settings on the sending and
receiving printers. When you turn the power on in Test and Service mode, the
printer reads the DIP switch communications settings. Set the receive printer to
the same communications DIP switch settings and turn the power on in Print
mode.
To perform selective transfer
1. Turn the On/Off switch to the off position.
2. Press down and hold the Feed/Pause button while turning on the printer.
The hardware configuration test label prints.
3. Connect the serial ports of the sending and receiving ports together with an
RS-232 null modem cable. For help, refer to “Connecting the Printer to Your
System” in Chapter 1 and “Communications Interfaces” in Appendix C.
4. Set the DIP switches on the sending printer for selective transfer as shown
in the Test and Service DIP Switch Settings table on page 6-4.
5. Press the Feed/Pause button on the receiving printer and then on the
sending printer to initiate selective transfer.
6. Exit Test and Service mode by turning the printer power off and returning
all DIP switches to their original settings.
To Next Page
Loading...
