Intermec 3400

HelvC
NugFont
Code39
Using Test and Service Mode
6-7
6
Resetting the Memory on Your Printer
Use memory reset if you want to return your printer to its default configuration
or if you need to increase the amount of memory available in your printer. You
can also use memory reset to clear pages and formats, user-defined characters
and fonts, configurations, tables, or all of these parameters.
To use memory reset
1. Turn the printer off.
2. Press and hold the Feed/Pause button while turning on the printer. The
printer prints a hardware configuration test label.
3. Set the DIP switches to reset a portion or all of the memory by using the
Test and Service Mode DIP Switch Settings table on page 6-4.
4. Hold the Feed/Pause button down for 1 second. The printer resets a portion
or all of its memory.
5. To exit Test and Service mode, turn the printer power off and then on.
To reset the entire memory on the 3400 printer
Note:
This procedure applies to the 3400C only. The 3400A and 3400B do not have the
memory reset button.
Note:
This procedure is identical to resetting the memory by removing the battery.
1. Turn the printer off.
Note:
You must turn off the printer before pressing the memory reset button or the
printer may not operate correctly.
2. Using a small screwdriver, press the memory reset button for 30 seconds.
The printer resets the entire memory.
3. Turn the printer on.