HelvC
NugFont
Code39
Getting Started
1-13
1
Connecting Your Printer to a Network
Host computer
Printers (end devices)
Printers (end devices)
3XXXU.O19
Controller
The network interface adapter (for example, Ethernet) connects to the parallel
port of the printer. Your network must be able to use XON/XOFF (software
and hardware flow control) protocol. If you are installing your printer in a
network environment, you may need to change the serial port settings to match
the requirements of your network. You can determine the communications
requirements for your network by referring to the controlling device
documentation.
If the controlling device is an Intermec product, refer to the following manuals
for instructions and information on the necessary cabling and connections.
•
9154 Multi-Drop Line Controller System Manual
(Part No. 048517)
•
9161B Installation Manual
(Part No. 049572)
•
9180 Network Controller User's Manual
(Part No. 054292)
•
Data Communications Reference Manual
(Part No. 044737)
•
RF System User's Manual
(Part No. 053574)
If you need to change the printer’s communications parameters, follow the
procedures in “Configuring the Serial Port for Communications” later in this
chapter.
To Next Page
Loading...
