Intermec CK71 Series - Vibrator Motor

TITLE
Model
DOCUMENT NO.
PAGE
CK71 Service Work Instructions
CK71A
SWICK71-000
Page 13 of 42
OPERATION:
Vibrator Motor
The vibrator motor is friction fit into the bottom housing assembly. It’s attached cable plugs into the keyboard PCB
assembly.
Tools Required
Description
Part Number
Tweezers
Parts Required
Item
Part Number
Description
Qty
1
324-025-002
Vibrator motor
1
2
906-016-007
Tape, Kapton-5/8W, RoHS
10mm
Removal
1. Remove the bottom housing assembly (refer to Bottom Housing operation).
2. Pull the vibrator motor out of its slot in the bottom housing.
Installation
1. Press the vibrator motor into its slot in the bottom housing.
2. Route the cable around away from the uSD/SIM door opening and install a piece of kapton tape as shown in the
picture below.
3. Re-install the bottom housing assembly. Refer to Bottom Housing operation.
1
2