Intermec CK71 Series - Battery Connector Seal

TITLE
Model
DOCUMENT NO.
PAGE
CK71 Service Work Instructions
CK71A
SWICK71-000
Page 39 of 42
OPERATION:
Battery Connector Seal
A seal around the battery pogo pin connector block on the keyboard PCB assembly was added sometime after the
original production release. This seal prevents moisture and other debris from entering the area around the battery
pogo pin block when the battery is not installed. This seal should only be installed and/or replaced on units that
already have it installed.
Tools Required
Description
Part Number
See other operations
Parts Required
Item
Part Number
Description
Qty
1
643-441-001
Connector,Plug Seal CK7X
1
Removal
1. Remove the bottom housing assembly (refer to Bottom Housing operation).
2. Remove the existing seal as needed.
Installation
1. Install the seal over the battery pogo pin block as shown in the picture below. It is a friction fit. There is no
adhesive liner. Be sure to align the notch in the seal with the PCB component as shown.
2. Re-install the Bottom Housing Assembly.
Align notch in seal with
this component