Intermec CK71 Series - Bottom Housing

TITLE
Model
DOCUMENT NO.
PAGE
CK71 Service Work Instructions
CK71A
SWICK71-000
Page 7 of 42
OPERATION:
Bottom Housing
The bottom housing will need to be removed to access internal assemblies or if it needs to be replaced. The bottom
housing is secured with 10 screws. There is a different spare bottom housing for each scan engine option due to
differences in the factory installed shock mounts and scan windows.
Tools Required
Description
Part Number
T10 Torx driver
T7 Torx driver
Parts Required
Item
Part Number
Description
Qty
1
715-578S-006
HOUSING,BOTTOM,ASSY C2, EX25 SPARE
1
1
715-578S-007
HOUSING,BOTTOM,ASSY C2, EV12 SPARE
1
1
715-578S-008
HOUSING,BOTTOM,ASSY C2, EA30 SPARE (and N5603)
1
2
800-570-002
SCREW 4-40X1/2 PH TORX W/NYL CRES ROHS
8
3
800-574-002
SCREW 2-56 X 7/16 PH TORX W/NYL CRES ROH
2
4
906-016-002
Kapton Tape (1.39 inches)
1
5
655-529-001
Adhesive, vibrator wiring
1
NOTE: A new bottom housing will not have any labeling on it
Removal
1. Remove the stylus from its storage slot in the back cover.
2. Remove the uSD/SIM card slot access cover.
3. Remove 10 screws. Discard the screws. The screws have a one time use seal. New screws must be used when
reinstalling the bottom housing.
1
3
2
4