Intermec CK71 Series - EV12 Scan Engine

TITLE
Model
DOCUMENT NO.
PAGE
CK71 Service Work Instructions
CK71A
SWICK71-000
Page 30 of 42
OPERATION:
EV12 Scan Engine
The EV12 scan engine is located on the scan bracket assembly. To service the scan engine you will need to remove
the scan bracket assembly.
Tools Required
Description
Part Number
T10 Torx driver
T7 Torx driver
Phillips screwdriver with #0 tip
Parts Required
Item
Part Number
Description
Qty
1
3-103019-01-54
EV12 Scan Engine
1
2
655-215-001
SHIELD,EV12,SCAN ENGINE
1
3
655-219-001
PAD, GROUND, EV12/EA30
1
4
224-877-0100
FLEX ASSY, COZUMEL, EV12
1
5
800-485-001
SCREW,M1.6x3.9,PH,BLK,NYLOK,ROHS
2
Removal
1. Remove the bottom housing assembly (refer to bottom housing operation).
2. Remove the scan bracket assembly (refer to Scan Bracket Assembly operation).
3. Using a #0 Phillips screwdriver remove two screws the secure the EV12 scan engine to the scan bracket assembly.
4. Slide the engine out of the bracket and disconnect the flex cable.
Slide engine out
and disconnect
flex
3
4
1
5
2
See engine
part detail
at right