Intermec CK71 Series - Page 9

TITLE
Model
DOCUMENT NO.
PAGE
CK71 Service Work Instructions
CK71A
SWICK71-000
Page 9 of 42
5. Place the bottom housing onto the top housing and push it down seating it into the overmolded seal around the
edge of the top housing. Be sure the vibrator and supercap cables are not pinched under the housing.
6. Install new screws. Torque them per the following pattern. Torque the eight 4-40 screws to 6.0+/-0.2 in-lb. Torque
the two 2-56 screws at each side of the battery compartment to 3.5+/-0.2 in-lb.
6. Reinstall the uSD/SIM card slot access cover.
7. If this is a new bottom housing the appropriate camera window will need to be installed. Refer to the Camera
Window operation.
8. If this is a new bottom housing new product labeling will also need to be applied. Refer to the Labeling operation.
1
2
6
10
0
7
3
5
9
8
4