Chapter 5 — Network Support
166 CN3 Mobile Computer User’s Manual
• SSID (Network Name) assumes the profile name unless another name is
entered in this field. If you want to connect to the next available network
or are not familiar with the network name, enter “ANY" in this field.
Consult your LAN administrator for network names.
• Check Enable Power Management to conserve battery power (default),
or clear this box to disable this feature.
Security
These are available from the 8021x Security drop-down list: None, PEAP
(page 168), TLS (page 170), TTLS (page 171), LEAP (page 174), and
EAP-FAST (page 175).
To disable 802.1x security and enable WEP encryption
1 Set 8021x Security as “None.”
2 Set Association to “Open.”
3 Set Encryption to “None.”
To enable WEP encryption
1 Set 8021x Security as “None” and Association to “Open” or “Shared” as
required to match the settings in your access point. “Open” is the
recommended choice as “Shared” key authentication has security
weaknesses.
2 Set Encryption to “WEP.”
3 Select a data transmission key from the Data TX Key drop-down list
near the bottom of this screen.
To Next Page
Loading...
