Chapter 7 — Configuring the Computer
CS40 Mobile Computer User’s Manual 73
7 If you choose TLS:
a Load a user and root certificate on your mobile computer. For
help, see “Loading a Certificate” on page 80.
b Enter a User Name and Subject Name.
c For Validate Server Certificate, choose Yes.
d (Optional) To increase your level of security, enter a Server 1
Common name and a Server 2 Common name.
Configuring WPA or WPA2 Personal (PSK) Security With Funk
After you configure the communications and radio parameters on
your mobile computer and select Funk as your security choice, you can
configure WPA-PSK or WPA2-PSK security.
To configure WPA-PSK or WPA2-PSK security with Funk:
1 Start Intermec Settings.
2 Choose Communications > 802.11 Radio > Funk Security.
3 Select the profile you want to configure.
4 For Association, choose WPA or WPA2.
5 For 8021x, choose None.
6 For Pre-Shared Key, enter the pre-shared key or passphrase.
The pre-shared key must be a value of 32 hex pairs preceded by 0x
for a total of 66 characters. The value must match the key value on
the access point. The passphrase must be from 8 to 63 characters.
After you enter a passphrase, the mobile computer internally
converts it to a pre-shared key. This value must match the
passphrase on the authenticator.
7 Save your settings.
Note: The correct date must be set on your mobile computer when
you enable Validate Server Certificate.
To Next Page
Loading...
Need help?
General
