Chapter 7 — Configuring the Computer
74 CS40 Mobile Computer User’s Manual
Configuring 802.1x Security With Funk
After you configure the communications and radio parameters on
your mobile computer and select Funk as your security choice, you can
configure 802.1x-WEP security with Funk. Intermec recommends that
you use WPA2-802.1x instead of 802.1x-WEP if possible.
To configure 802.1x security with Funk:
1 Start Intermec Settings.
2 Choose Communications > 802.11 Radio > Funk Security.
3 Select the profile you want to configure.
4 For Association, choose Open.
5 For Encryption, choose WEP.
6 For 8021x, choose TTLS, PEAP, or TLS.
7 If you chose TTLS or PEAP:
a Enter a User Name.
b For Prompt for Credentials, choose Enter credentials now.
c Enter a User Password.
d For Validate Server Certificate, choose Yes.
8 If you choose TLS:
a Load a user and root certificate on your mobile computer. For
help, see “Loading a Certificate” on page 80.
b For Validate Server Certificate, choose Yes.
c Enter a User Name and Subject Name.
9 (Optional) To increase your level of security, enter a Server 1
Common name and a Server 2 Common name.
10 Save your settings.
To Next Page
Loading...
Need help?
General
