Chapter 7 — Configuring the Computer
CS40 Mobile Computer User’s Manual 75
Configuring Static WEP Security With Funk
After you configure the communications and radio parameters on
your mobile computer and select Funk as your security choice, you can
configure static WEP security with Funk. Intermec recommends that
you use WPA2-PSK instead of WEP if possible.
To configure static WEP security with Funk security:
1 Start Intermec Settings.
2 Choose Communications > 802.11 Radio > Funk Security.
3 Select the profile you want to configure.
4 For Association, choose Open.
5 For Encryption, choose WEP.
6 For 8021x choose None.
7 Define a value for the keys you want to use. You can define up to
four keys (Key 1 through Key 4).
Enter an ASCII key or a hex key that is either 5 bytes or 13 bytes
long depending on the capability of the radio. Set a 5- byte value for
64-bit WEP or a 13-byte value for 128-bit WEP. Hex keys must be
preceded by 0x and contain 5 or 13 hex pairs.
8 For Transmit key, choose the key you want to use for transmitting
data.
9 Save your settings.
Using Open (No Security) Associations With Funk
You can configure your mobile computer for no security with Funk.
To configure Open security with Funk:
1 Start Intermec Settings.
2 Choose Communications > 802.11 Radio > Funk Security.
3 Select the active profile you are using.
4 For Association, choose Open.
5 For Encryption, choose None.
6 Tap OK. Your settings are saved.
To Next Page
Loading...
Need help?
General
