Chapter 7 — Configuring the Computer
76 CS40 Mobile Computer User’s Manual
About Microsoft Security
With Microsoft Wireless Zero Configuration (WZC), you can
configure:
• WPA
• 802.1x
• Static WEP
Selecting Microsoft Security
The default security setting is Funk. If you want to use Microsoft
Wireless Zero Configuration (WZC) security, you need to select it as
your security choice. After you select Microsoft as your security choice,
you are prompted to save your settings and reset your computer for the
change to take effect.
To select Microsoft security:
1 Start Intermec Settings. For help, see “Configuring the
Computer” on page 53.
2 Choose Communications > 802.11 Radio > Security Choice.
3 From the Security Choice list, select Microsoft Security. An alert
box appears telling you that you must save your settings and warm
boot the mobile computer for the new security choice to take effect.
4 Choose Yes. The computer resets and starts with Microsoft
Security as the Security Choice.
Configuring WPA or WPA2 Enterprise (802.1x) Security With
Microsoft
After you configure the communications and radio parameters on
your mobile computer and select Microsoft as your security choice,
you can configure WPA or WPA2 Enterprise (802.1x) security with
Microsoft.
To configure WPA or WPA2 Enterprise (802.1x) security with
Microsoft:
1 Start Intermec Settings.
2 Choose Communications > 802.11 Radio > Microsoft Security.
To Next Page
Loading...
Need help?
General
