Chapter 1— Getting Started
3400, 3440, and 3600 Bar Code Label Printer User’s Manual 5
3 Plug the AC power cord into the receptacle at the rear of the printer.
Plug the other end of the power cord into a grounded wall outlet or
surge protector.
4 Turn the On/Off switch to the on position. When you power on the
printer, the Power On LED lights, the Empty/Pause LED flashes, and
the platen roller advances. The yellow Empty/Pause LED then stays on
steady because you have not loaded media yet.
Opening the Printer
You need to open the printer every time you load media or perform
maintenance procedures.
To open the printer
1 Place the fingers of your right hand between the two notches on the
lower edge of the media cover (the media cover release) and pull the
bottom of the media cover away from the base of the printer.
3XXXU.005
Power/Data
3440
Alert
F
e
ed/Pause
Empty/Pause
Intermec
1
3
2
2 Grasp the front of the media cover with your left hand and lift the front
of the media cover upward to release it from the printer frame.
3 Lift the media cover away from the top of the printer.
Loading Media for Fanfold Printing
Use the sample of fanfold media provided in the Media Envelope to
complete the following procedures. In fanfold printing, you place a stack
of fanfold media at the rear of the printer and feed it into the printer
through a slot in the rear cover. Refer to Chapter 2, “Operating the
Printer,” for instructions on loading rolls of media.
To Next Page
Loading...
Need help?
General