Intermec EasyCoder F4 - Page 56

Intermec EasyCoder F4 – Installation & Operation Ed. 3 55
Chapter 7 Setting Up the Printer
Direct Thermal Printing (North America)
DT Type/ Paper Label Label Max Rec. Print Speed (mm/sec)
1
Speed Designation Constant Factor Picket Fence Bar Code
2
Ladder Bar Code
Top Coated/ Duratherm II Tag
3
112 40 100 100
Standard Duratherm II 95 40 100 100
Top Coated/ Duratherm Ltg 92 40 175 175
High Duratherm IR 82 40 150 150
Thermal Transfer Printing (North America)
Ribbon Receiving Ribbon Ribbon Label Max Rec. Print Speed (mm/sec)
1
Type Material Constant Factor Offset Picket Fence Bar Code
2
Ladder Bar Code
Basewax Duratran II 55 25 0 200 200
(4022) Duratran II Tag
3
70 25 0 200 200
Duratran VG 70 25 0 150 150
Kimdura 70 25 0 200 200
Kimdura Tag 70 25 0 200 200
Syntran 65 25 0 200 200
Standard Duratran II 65 25 0 150 150
(4085) Duratran II Tag
3
75 25 0 150 150
Kimdura 80 25 0 150 150
Kimdura Tag 80 25 0 150 150
Syntran 70 25 0 150 150
Premium Duratran II 65 25 0 150 150
(5050) Duratran II Tag
3
75 25 0 150 150
Kimdura 80 25 0 150 150
Kimdura Tag 80 25 0 150 150
Matte Polyester 70 25 0 150 150
Syntran 70 25 0 150 150
Super Premium Polyester 90 25 0 200 200
1
/. Exceeding the recommended print speed may cause the printhead to wear out prematurely. If the ambient temperature is lower
than +15°C (+59°F), decrease print speed by 50 mm/sec.
2
/. Also applies to printing of text, images, lines, and boxes.
3
/. Requires high printhead pressure (see Chapter 13 “Adjustments, Printhead Pressure.”)
Media, cont.
Setup Parameters, cont.