EasyLAN Wireless Interface Kit Installation Instructions 19
4
Setup in Fingerprint
is chapter explains how to set up the wireless
network communication in printers running Intermec
Fingerprint v8.40 (or later). e only requirement on
the PC side is a terminal program that can transmit
and receive ASCII characters on an RS-232 line.
us, this method is recommended when you do not
have the opportunity to run the PrintSet program,
for example when you are using an operating system
other than Windows.
For information on how to set up the network
communication in printers running IPL, refer to
Chapter 5.
To Next Page
Loading...
