Intermec EasyCoder PF2i Installation Instructions

30 EasyLAN Wireless Interface Kit Installation Instructions
Chapter 4 — Setup in Fingerprint
Examples
SETUP "8021x","EAP_TYPE","TTLS|LEAP|PEAP|OFF"
Sets preferred EAP type.
SETUP "8021x",".EAP_USER","Admin01"
Sets logon username to “Admin01”.
SETUP "8021x","EAP_PASS","InfoTech"
Sets logon password to “InfoTech”.
Note: It is not possible for any user to read the EAP_PASS
value.
SETUP "8021x","TTLS_USER","Manufacturing"
Sets TTLS outer name to “Manufacturing”.
SETUP "8021x","INNER_AUTH","PAP|MSCHAPv2|EAP/
MSCHAPv2|EAP/MD5|EAP/GTC"
Sets inner authentication type (TTLS/PEAP only).
SETUP "8021x","CA_CERT","/tmp/mycacert.cer"
Installs overriding CA certificate (TTLS/PEAP only).
SETUP "8021x","CA_CERT","/tmp/mycacert.pfx@
verysecret"
Installs overriding CA certificate (TTLS/PEAP only), encrypted with the
pass phrase “verysecret”.
SETUP "8021x",".SERVER_CN1","Printer33"
Sets common name 1 to “Printer33” (TTLS/PEAP only).
SETUP "8021x",".SERVER_CN2","Printer34"
Sets common name 2 to “Printer34” (TTLS/PEAP only).
SETUP "8021x","VALIDATE","ON|OFF"
Enables or disables validation of the server certificate (TTLS/PEAP
only).
SETUP WRITE/GET for all settings returns the set value, except for
EAP_PASS which always returns “****” if configured, and for “CA_
CERT” which returns the common name of the last certificate authority
successfully installed (but not the path to the file).
An additional item is “STATE”, which is read-only for all users:

Intermec EasyCoder PF2i Specifications

General

Brand	Intermec
Model	EasyCoder PF2i
Category	Printer Accessories
Language	English