EasyLAN Wireless Interface Kit Installation Instructions 35
Chapter 4 — Setup in Fingerprint
SETUP"NETWORK,IP SELECTION,DHCP+BOOTP" (default)
SETUP"NETWORK,IP SELECTION,MANUAL"
SETUP"NETWORK,IP SELECTION,DHCP"
SETUP"NETWORK,IP SELECTION,BOOTP"
1
/. However, anybody can change the IP selection method from the
printer’s keyboard using the Setup Mode.
IP Address
If you have selected MANUAL as manual selection method, you can
assign a permanent IP address to the printer:
SETUP"NETWORK,IP ADDRESS,nnn.nnn.nnn.nnn"
Subnet Mask
If you have selected MANUAL as manual selection method, you can
specify a netmask for the printer:
SETUP"NETWORK,NETMASK,nnn.nnn.nnn.nnn"
Default Router
If you have selected MANUAL as manual selection method, you can
specify a default router for the printer:
SETUP"NETWORK,DEFAULT ROUTER,nnn.nnn.nnn.nnn"
Name Server
If you have selected MANUAL as manual selection method, you can
specify a name server for the printer:
SETUP"NETWORK,NAME-SERVER,nnn.nnn.nnn.nnn"
Finishing the Setup
You can now disconnect the printer from the PC and use your web
browser to test the wireless communication as described in Chapter 6,
assuming that there is a working wireless LAN and the printer is inside
the coverage area of an access point.
To Next Page
Loading...
