EasyLAN Wireless Interface Kit Installation Instructions 33
Chapter 4 — Setup in Fingerprint
wrong region/domain is set, please contact your Intermec representative
immediately. Continued use of the EasyLAN Wireless network interface
with an incorrect REGION setting may be in violation of applicable
laws.
e region setting will not be reset to default, even if a factory default
upgrade is performed.
e following regulatory domains are implemented:
Regulatory Domains
Value Countries Allowed Channels
FCC (or USA) U.S.A 1-11 (default)
IC (or Canada) Canada 1-11
ETSI (or EU) EU countries
1
+ Iceland,
Liechtenstein, Norway, and
Switzerland
1-13
MKK (or Japan) Japan 1-14
1
/. Certain restrictions apply to outdoor use in France.
SETUP GET "wlan",".REGION",A$
Gets the active region in A$.
Reading Wireless Connection Setup
All settings can be returned to the host via a specified serial
communication port, usually "uart1:", using the Fingerprint instruction
SETUP WRITE "wlan" or SETUP WRITE "8021x".
Example:
SETUP WRITE "wlan","uart1:"
Provided the current user is logged in as admin, this will produce a full
list of wireless setup parameters:
SSID qwerty
WEP1 ****
WEP2 ****
WEP3
WEP4
.WEP_KEY 0
AUTH SHARED
WPA OFF
To Next Page
Loading...
