PARITY:
BOOTP
PARITY:
DHCP
PARITY:
MANUAL
SETUP:
NETWORK
NETWORK:
IP SELECTION
NETWORK:
IP ADDRESS
NETWORK:
NETMASK
NETWORK:
DEFAULT ROUTER
NETWORK:
NAMESERVER
IP SELECTION:
DHCP+BOOTP
IP ADDRESS:
192.168.1.79
NETMASK:
255.255.255.0
DEFAULT ROUTER:
192.168.1.1
NAMESERVER:
192.168.1.7
NETWORK:
MAC ADDRESS
MAC ADDRESS:
00104017b80e
Read-only Read-only Read-only Read-only Read-only
These menus will only be displayed when an optional EasyLAN interface board is installed.
PARITY:
DHCP+BOOTP
PARITY:
BOOTP
PARITY:
DHCP
SETUP:
NETWORK
NETWORK:
IP SELECTION
NETWORK:
IP ADDRESS
NETWORK:
NETMASK
NETWORK:
DEFAULT ROUTER
NETWORK:
NAMESERVER
IP SELECTION:
MANUAL
IP ADDRESS:
0.0.0.0
NETMASK:
0.0.0.0
DEFAULT ROUTER:
0.0.0.0
NAMESERVER:
0.0.0.0
NETWORK:
MAC ADDRESS
MAC ADDRESS:
00104017b80e
Read-only Read-only Read-only Read-only Read-only
These menus will only be displayed when an optional EasyLAN interface board is installed.
EasyLAN Wireless Interface Kit Installation Instructions 51
Chapter 5 — Setup in IPL
4 Press the key. e display shows the default setting:
IP SELECTION:
DHCP+BOOTP
5 Here, you can select the method for assigning the IP address for the
printer as discussed earlier. ere are four options; DHCP+BOOTP,
MANUAL, DHCP, and BOOTP. If you do not use a DHCP or
BOOTP server, you can either set the IP address manually or use the
ARP'n'PING method.
6 Use the or keys to browse through the options. When the desired
option is displayed, press the <Enter> key.
Reading the IP Address
1 After having selected the method for assigning the IP address, the
display shows:
NETWORK:
IP ADDRESS
Example of the network setup when an automatic IP selection method is used.
Example of the network setup when the manual IP selection method is used or when
the network does not have an DHCP or BOOTP server.
To Next Page
Loading...
Need help?
General
