EasyLAN Wireless Interface Kit Installation Instructions 47
Chapter 5 — Setup in IPL
<STX><SI>ws,VALIDATE,ON|OFF<ETX>
Enables validation of the server certificate (TTLS/PEAP only).
All variables may be transmitted by means of:
<STX><SI>wt,[variable name]<ETX>
except EAP_PASS which always returns “****” if configured, CA_CERT
which transmits the name of the last certificate authority successfully
installed, and DOWNLOAD_CA which does not transmit anything.
An additional read-only variable is the supplicant state, STATE:
<STX><SI>wt,STATE<ETX>
Transmits the supplicant state: “Disabled”, “Failing”, “Authenticating”,
or “Authenticated”.
Note: If you start the printer with EAP type set to OFF and
then change the EAP type to TTLS, LEAP, or PEAP, you need
to reboot the printer for your new settings to take effect. Until
you reboot, STATE returns “Disabled”.
802.1x supplicant state, EAP type, outer name, inner authentication,
installed root certificate, server common names, and server certificate
validation can be seen on the printer's web page and the network test
label.
Reading Other Wireless Connection Variables
In addition to SSID, WEP, and 802.1x information, the following
wireless connection variables can be read using IPL commands:
• Active channel
1,3
• MAC address of the access point
1
• Signal strength
1,3
• Speed
1
• Region
2
1
/. e information is also given on the network test label and on the
web page.
2
/. e current region is also presented on the web page.
To Next Page
Loading...
Need help?
General
