34 EasyLAN Wireless Interface Kit Installation Instructions
Chapter 4 — Setup in Fingerprint
WPA_PSK
.REGION USA (FCC)
ROAM 1
# CHANNEL 11
# AP_MAC 00:10:40:25:ee:a9
# SIGNAL 49
# SPEED 11
ACTIVE 1
Setting Up Network Parameters
In this document, the use of setup strings or setup files are described.
Network parameters could also be set via the printer’s built-in keyboard
as described in the printer user’s guide.
New Line
Set the New Line parameter using a setup string or setup file:
SETUP"NET-COM,NET1,NEW LINE,CR/LF"
SETUP"NET-COM,NET1,NEW LINE,LF"
SETUP"NET-COM,NET1,NEW LINE,CR"
Default is CR/LF.
IP Selection Method
ere are four methods for setting the IP address. DHCP, BOOTP, and
DHCP+BOOTP let the server assign a temporary IP address to the
printer. e method to choose depends on the server. DHCP, BOOTP,
and DHCP+BOOTP also sets the subnet mask, default router, and
name server automatically. If the server neither supports DHCP nor
BOOTP, or if you want to set a permanent IP address manually, use the
MANUAL option. In this case, you will also have to set the subnet mask,
default router, and name server manually via the printer’s keyboard.
Always consult the network administrator before assigning
a permanent IP address to avoid having more than one
device with the same IP address in the network.
Set the IP selection method parameter using a setup string or setup file
(by default only allowed for admin
1
):
To Next Page
Loading...
Need help?
General
