Appendix A — Specifications
PX4i and PX6i High Performance Printer User’s Manual 153
Black Mark Y-Position (f)
Intermec recommends that you place the black mark as close to the
front edge of the ticket as possible and use a negative Stop Adjust
value to control the media feed, so the tickets can be properly torn off.
Media Type
Set media type to one of these values:
• Fingerprint: MARK STOCK
• IPL: TICKET (w MARK)
Note: The black mark should be non-reflective carbon black on a
whitish background. Do not allow a perforation to break the edge of
the media, because the media may split and jam the printer.
Note: Try to avoid preprint that may interfere with the detection of
the black mark. However, if your are running Fingerprint, you can use
the command LBLCOND to temporarily disable the sensor for a
specified amount of media feed to avoid unintentional detection. For
help, see the Intermec Fingerprint Command Reference Manual.
To Next Page
Loading...
