Intermec SR30 User Manual

Chapter 2 — Connecting and Configuring the SR30
14 SR30 Handheld Scanner User’s Guide
Serial Parameter Bar Codes
If your SR30 is connected to a host with an RS-232 cable,
configure your SR30 serial parameters to match the host device.
This section contains bar codes for basic serial parameters. To
configure additional serial parameters, see EasySet version
5.6.0.0 or later.
* = default
Baud Rate
1200
2400
4800
9600
19200*
38400
57600
Note: By default, RTS/CTS hardware protocol is disabled. To
enable this parameter, use EasySet version 5.6.0.0 or later. RTS/
CTS hardware protocol operates only in one direction. The
SR30 requests permission from the host to transmit and
monitors host transmissions.

Intermec SR30 Specifications

General

Type	Handheld bar code reader
Scanner type	-
Optical sensor resolution	- pixels
Light levels (direct sunlight)	0 - 100000 lx
Linear (1D) barcodes supported	Code 128, Code 39, Code 93, EAN 2, EAN 5, EAN-13, EAN-8, MSI, Plessey, Telepen, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Codablock, Data Matrix
Input voltage	5 V
Power source type	USB
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Product color	Blue, Grey
International Protection (IP) code	IP30

Weight and Dimensions

Width	72.5 mm
Weight	190 g