Chapter 1 — Learning About the SR30
4 SR30 Handheld Scanner User’s Guide
Scanning Bar Codes
The SR30 is used to scan bar code data. When you unpack the
SR30, these bar code symbologies are enabled:
• Code 39
• Code 128/GS1-128
• UPC/EAN
• DataMatrix (SR30 Area Imager only)
• PDF 417 (SR30 Area Imager only)
If you are using bar code labels that are encoded in a different
symbology, you need to enable the symbology on your SR30. Use
EasySet version 5.6.0.0 or later to enable and disable symbologies
for your scanner. EasySet is available on the Intermec web site at
www.intermec.com/EasySet.
To scan a bar code
1 Point the scanner window at the bar code label and hold the
SR30 steady about two feet from the label.
To Next Page
Loading...
