Intermec SR30 User Manual

Chapter 3 — Troubleshooting and Maintaining the SR30
SR30 Handheld Scanner User’s Guide 21
Maintaining the SR30
To keep your SR30 in good working order, you may need to
upgrade the SR30 and clean the scanner window.
Upgrading the SR30
Use the procedures below to upgrade the:
• Host Interface Processor (HIP)
• Imager engine firmware
The SR30 contains a Host Interface Processor (HIP). You can
upgrade the HIP firmware.
To upgrade the SR30, you need:
• an RS-232 accessory cable. For more information, see “Cable
Accessories” on page 34.
• a PC running Microsoft® Windows® XP with SP2 or
Microsoft Windows 2000.
• EasySet version 5.6.0.0 or later.
• the SR30 HIP upgrade package.
To upgrade the SR30 HIP or imager firmware
1 Download the latest SR30 HIP upgrade package from the
Intermec web site at www.intermec.com.
a Go to Support > Downloads.
b If necessary, click the link to search the product
downloads.
c From the Select A Product drop-down list, choose Bar
Code Scanners: SR30 Handheld Scanner.
d Click the link to download the HIP firmware upgrade
package and save it to your PC.
e Unzip the .zip file.
2 Connect your SR30 to a host PC with an RS-232 cable.

Intermec SR30 Specifications

General

Type	Handheld bar code reader
Scanner type	-
Optical sensor resolution	- pixels
Light levels (direct sunlight)	0 - 100000 lx
Linear (1D) barcodes supported	Code 128, Code 39, Code 93, EAN 2, EAN 5, EAN-13, EAN-8, MSI, Plessey, Telepen, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Codablock, Data Matrix
Input voltage	5 V
Power source type	USB
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
Product color	Blue, Grey
International Protection (IP) code	IP30

Weight and Dimensions

Width	72.5 mm
Weight	190 g