Chapter 4 — Enabling and Configuring Symbologies
SR60 Scanner Programmer’s Reference Manual 115
Read Verification
You can set the number of minimum reads required to verify
UPC/EAN symbologies.
To set the number of minimum reads
1 Scan the SET bar code.
2 Scan a bar code to select which symbology to verify.
3 Scan the bar code on page 116 that represents the number of
times you wish a bar codes label of that symbology type to be
read before transmission to the host from the list.
4 Repeat Steps 2 and 3 until read verification has been modified
for each symbology you enabled.
5 Scan the END bar code.
Enable 5-Digit ---------
Enable Euro 4-
Digit ---------
Enable Euro 5-
Digit ---------
END------------------------------------
To Next Page
Loading...
