Chapter 3 — Configuring Label Transmit Settings
SR60 Scanner Programmer’s Reference Manual 63
5 Scan the END bar code.
You have changed the default Label ID for UPC-A from A to A1.
Selecting the Symbology
This section contains bar codes that represent each symbology.
You scan these bar codes when, for example, you configure a
symbology-specific label ID. You may scan only one symbology
per programming session.
Setting Label ID Characters by Symbology
SET-------------------------------------
Code 39 ---------
PharmaCode 39 ---------
Code 128 ---------
UCC/EAN 128 ---------
To Next Page
Loading...
