Chapter 4 — Enabling and Configuring Symbologies
SR60 Scanner Programmer’s Reference Manual 121
Standard 2 of 5/IATA Options
This section describes the Code 39 options and contains the
programming bar codes you can use to configure those options.
About Standard 2 of 5/IATA Options
The Standard 2 of 5/IATA symbologies have the following
programmable features:
•Check Digit
• Label Length Format
•Read Verification
Check Digit
Check Digit calculates the check digit to verify that the check
digit contained in the bar code label is correct. If you enable this
feature, your bar codes must contain a check digit.
Set to Two Reads ---------
Set to Three Reads ---------
Set to Four Reads ---------
END------------------------------------
To Next Page
Loading...
