Chapter 3 — Configuring Label Transmit Settings
56 SR60 Scanner Programmer’s Reference Manual
Setting an EOM for a USB Interface
For the USB interface, the global character that is added at the
end of every scan is an End of Message (EOM) character, not a
Postamble (suffix). However, if you use an EOM without a suffix,
the EOM acts as the suffix.
The next procedure describes how to set an EOM for a USB
interface. If the EOM you want to set is not in Step 2, set the
EOM to None and set a suffix. For help, see
“Setting a Prefix or
Suffix for a USB Interface” on page 54.
To set an EOM for a USB interface
1 Scan this bar code.
2 Scan one of these EOM bar codes. The default setting is
Return.
$% /
Start
DP5
EOM=Enter
DP3
EOM=Field Exit
DP6
EOM=CR/LF
To Next Page
Loading...
