Intermec SR60

Chapter 3 — Configuring Label Transmit Settings
SR60 Scanner Programmer’s Reference Manual 61
Setting the Label ID Location
You can specify the location where Label ID characters are to be
placed in relation to scanned label data. The location you choose
will be applied universally to all symbologies; you cannot specify
a symbology-specific label ID location.
The locations include:
• None (for example, prefix, label data, suffix)
• Prefix (for example, prefix, label ID, label data, suffix)
• Suffix (for example, prefix, label data, label ID, suffix)
To set the label ID location
1 Scan the SET bar code.
2 Scan the bar code for the location you chose.
3 Scan the END bar code
.
Setting Label ID Location
SET-------------------------------------
Label ID = None ---------
Position Label
ID as Prefix ---------