Intermec SR60

Chapter 2 — Configuring Interface Settings
18 SR60 Scanner Programmer’s Reference Manual
Use the bar codes in “Keypad Bar Codes” on page 160 to scan two
digits representing the number of Pre-Noise Transitions padded
with leading zeros. For example, 03 = three transitions, 08 = eight,
and 15 = fifteen.
END------------------------------------
Post-Noise Transitions Settings
SET-------------------------------------
Don’t Transmit
Post-Noise ---------
Set Post-Noise
Transitions ---------
Use the bar codes in “Keypad Bar Codes” on page 160 to scan two
digits representing the number of Post-Noise Transitions padded
with leading zeros. For example, 03 = three transitions, 08 = eight,
and 15 = fifteen.
END------------------------------------