Chapter 4 — Enabling and Configuring Symbologies
SR60 Scanner Programmer’s Reference Manual 89
• The Set Second Fixed Length bar code on page 93
instructs the scanner that the next two programming
labels scanned will define the second fixed label length.
This setting can be any even number of characters between
02 and 50 characters.
• The No Second Fixed Length bar code on page 93
configures the scanner to recognize only the first fixed
length.
Read Verification
Read Verification is the number of times the scanner is required
to read the bar code data before sending the label data to the host.
Configuring the Interleaved 2 of 5 Options
Scan the following bar codes to configure the Interleaved 2 of 5
symbology options.
Note: For this symbology, the scanner decodes up to 50
characters, but the actual length read varies depending
upon the interface type, bar code physical size, and print
quality.
Check Digit
SET------------------------------------
Don’t Calculate ---------
Calculate ---------
To Next Page
Loading...
