Intermec SR61T1D Programmer's Reference Manual

Chapter 4 — Enabling and Configuring Symbologies
100 SR60 Scanner Programmer’s Reference Manual
6 Scan the END bar code.
Fixed Length Format
The scanner offers the option of requiring Codabar labels to have
one or two fixed lengths in the Fixed Label Format.
To set Codabar symbology to Fixed Length Format
1 Identify the fixed length settings you want to make.
2 Scan the SET bar code.
3 Scan the Enable Fixed Length Format bar code.
4 Scan the Set First Fixed Length bar code.
5 Using the Digits bar codes on page 102, scan the digits to set
the first fixed label length you identified in Step 1.
Note: To set a label length less than ten, you must scan a zero
digit first and then the length digit (such as 04, 06, or 08).
Variable Length Format
SET------------------------------------
Enable Variable
Length Format ---------
Set Minimum
Label Length ---------
END------------------------------------

Intermec SR61T1D Specifications

General

Brand	Intermec
Model	SR61T1D
Category	Barcode Reader
Language	English