Chapter 4 — Enabling and Configuring Symbologies
SR60 Scanner Programmer’s Reference Manual 131
length to 16. If you select variable length format, there is one
more bar code label to scan:
• The Set Minimum Label Length bar code on page 133
selects the minimum label length that the scanner will
recognize. The minimum label length for this symbology
must be between 04 and 16. Set the Minimum Length as
high as your application allows.
• The Enable Fixed Length Format bar code on page 134
directs the scanner to read only one or two label lengths. If
you select fixed length format, there are three bar code labels
for programming your scanner to read either one or two fixed
lengths. The labels are:
• The Set First Fixed Length bar code on page 135 instructs
the scanner that the next two programming labels scanned
will define the first fixed label length. This setting must be
between 04 and 16 characters.
• The Set Second Fixed Length bar code on page 135
instructs the scanner that the next two programming
labels scanned will define the second fixed label length.
This setting must be between 04 and 16 characters.
• The No Second Fixed Length bar code on page 135
configures the scanner to recognize only the label length
chosen as the first fixed length.
Read Verification
Read Verification is the number of times the scanner is required
to read the bar code data before sending the label data to the host.
Configuring the MSI /Plessey Options
Scan the following bar codes to configure the MSI/Plessey
symbology options.
Check Digit
SET-------------------------------------
To Next Page
Loading...
Need help?
General
