Intermec SR61T1D Programmer's Reference Manual

Chapter 4 — Enabling and Configuring Symbologies
SR60 Scanner Programmer’s Reference Manual 91
6 Scan the END bar code.
Fixed Length Format
All interfaces that are shipped with the standard factory
configuration are set to read variable length labels. If you switch
from the variable to fixed length format, the default label lengths
are 14 characters and 8 digits. All fixed length settings must be an
even number.
To set Interleaved 2 of 5 Fixed Length Format
1 Identify the fixed length settings you want to make.
2 Scan the SET bar code.
3 Scan the Enable Fixed Length Format bar code.
Note: To set a label length less than ten, you must scan a zero
digit first and then the length digit (such as 04, 06, or 08).
Variable Length Format
SET------------------------------------
Enable Variable
Length Format ---------
Set Minimum
Label Length ---------
END------------------------------------

Intermec SR61T1D Specifications

General

Brand	Intermec
Model	SR61T1D
Category	Barcode Reader
Language	English