Chapter 4 — Enabling and Configuring Symbologies
92 SR60 Scanner Programmer’s Reference Manual
4 Scan the Set First Fixed Length bar code.
5 Using the Digits bar codes on page 93, scan the digits to set
the first fixed label length. The length must be an even
number.
• If you need to set a second fixed length, continue with
Step 6.
• If you do not need to set a second fixed length, scan the
No Second Fixed Length bar code and skip to Step 8.
6 Scan the Set Second Fixed Length bar code.
7 Using the Digits bar codes on page 93, scan the digits to set
the second fixed label length.
8 Scan the END bar code.
Note: To set a label length less than ten, you must scan a zero
digit first and then the length digit (such as 04, 06, or 08).
Note: To set a label length less than ten, you must scan a zero
digit first and then the length digit (such as 04, 06, or 08).
Fixed Length Format
SET------------------------------------
Enable Fixed
Length Format ---------
Set First Fixed
Length ---------
To Next Page
Loading...
Need help?
General
