Chapter 3 — Configuring Label Transmit Settings
54 SR60 Scanner Programmer’s Reference Manual
Setting a Prefix or Suffix for a USB Interface
Use this procedure to set a prefix or suffix.
To set a prefix or suffix for a USB interface
1 Scan these bar codes.
2 Scan the Preamble (prefix) or the Postamble (suffix) bar code.
3 Using the Full ASCII Chart on page 165, scan up to 19
characters. Use the Null character to clear the prefix or suffix.
$% /
Start
DH I
Lower Case = Enable
DP0
EOM = None
Q01
Preamble
Q02
Postamble
Code 39 Min Length = 1
To Next Page
Loading...
