Intermec SR61T1D Programmer's Reference Manual

Chapter 4 — Enabling and Configuring Symbologies
130 SR60 Scanner Programmer’s Reference Manual
MSI/Plessey Options
This section describes the MSI/Plessey options and contains the
programming bar codes you can use to configure those options.
About MSI/Plessey Options
The MSI/Plessey symbology has the following programmable
features:
•Check Digit
• Label Length Format
•Read Verification
Check Digit
Check Digit calculates the check digit(s) to verify the labels
contents have been read correctly. If you enable this feature, your
bar codes must include one or two check digits. You may also
choose to transmit or not transmit the check digit(s).
• The Calculate bar code on page 132 enables calculation of the
check digits. The Don’t Calculate bar code disables
calculation.
• The Transmit bar code on page 132 enables transmission of
MSI/Plessey check digit(s). The Don’t Transmit bar code
disables transmission.
• The One Check Digit bar code and the Two Check Digits bar
code on page 132 specifies either one or two check digits.
Label Length Format
Label length format permits the selection between variable length
or fixed length formats. For best performance, Intermec
recommends that you use the Fixed Length settings when your
application requires only one or two label lengths.
• The Enable Variable Length Format bar code on page 133
directs the scanner to read all labels from the minimum label
END-----------------------------------

Intermec SR61T1D Specifications

General

Brand	Intermec
Model	SR61T1D
Category	Barcode Reader
Language	English