Intermec SR61T1D Programmer's Reference Manual

Appendix A — Factory Default Configuration
152 SR60 Scanner Programmer’s Reference Manual
Factory Default Configuration
The following tables list most of the default configuration values
for the SR60 scanner. These tables also serve as a worksheet
where you can record the changes you make.
For help restoring your scanner to these values, see “Restoring
Factory Default Settings” on page 11.
Wand Emulation Interface Defaults
Feature Default Your Setting
Polarity Space high/Bar low
Signal Speed High
Data Format Normal
Idle State High
Pre-Noise 3
Post-Noise 3
Transmit C128 Function
Characters
Disable
Keyboard Wedge Interface Defaults
Feature Default Your Setting
Connect to Laptop/No
Keyboard Attached
Disable
Send Control/Function
Characters
Send
Caps Lock Off
Country Mode USA
Intercharacter Delay 0
Quiet Interval 100 ms

Intermec SR61T1D Specifications

General

Brand	Intermec
Model	SR61T1D
Category	Barcode Reader
Language	English